Connecté en tant que :
filler@godaddy.com
Connecté en tant que :
filler@godaddy.com
A simple, easy way to connect your KENWOOD RADIO to other devices!
The VE2DX Electronics KIB1 is a straightforward, easy-to-use break-out box for KENWOOD radios. Thanks to DIN13 connections, your KENWOOD RADIO ACCESSORY port is in the back of your radio, and eight 3.5mm mono connectors allow you to connect your devices.
WHY?
Simple: trying to make a DIN13 is basically a radio killer! The pins are so tight that they are challenging to make, and you can easily blow your radio in smoke if you are not careful.
I KNOW; I did it!
With our KIB1, you don't have to worry about that; they are premade, and we offer good-quality preassembled cables for your radios. The connections to your devices are made simply by using 3.5mm (1/8th) cables.
Will it work on my older radio?
The VE2DX Electronics KIB1 is made for radios with DIN13 ACC1 connectors in the back.
It will work on radios as old as the TS-450, TS-690 to the TS-570, TS-890, and TS-990, as long as they have the DIN 13Pin ACCESSORY in the back.
What features do you offer?
The VE2DX Electronics KIB1 as;
- DIN13 radio ACCESSORY connections.
- Eight separate 3.5mm (1/8th) mono jacks for eight different signals from the radio (Note 1).
- ALL Signals and Grounds on the VE2DX Electronics KIB1 are RFI-Filtered.
- ALL VE2DX Electronics designed PCBs are always fully shielded on both sides.
Note 1: Older RADIOS may not offer you all signals, please refer to your user manual to confirm what signals will be available.
Do you make these yourself?
This is an easy question... YES! All electronics design, PCB design, and firmware are made by US and no one else! VE2DX Electronics is a proud Canadian Company; we make all our products ourselves.
Our third-generation KENWOOD ACCESSORY BREAKOUT boxes (KIB1) are a significant evolution of the original ICOM IAB, IAB2, and IAB3-DUAL. This KENWWOD VERSION supports 13-pin DIN connectors and converts to 3.5mm audio jacks.
The KIBs are minimal external interfaces for the KENWOOD family of Radios, offering very simple access to the signals available from the ICOM ACC connectors.
The KIB1 offers eight external 3.5mm outputs from your KENWOOD A. Its 13-pin DIN connectors cover any KENWOOD radio with DIN ACCESSORY connectors, from the ICOM TS-450 to the TS-990.
The KIB1 3D-printed enclosure gives easy simple access to all the KENWOOD accessory signals.
VE2DX Electronics Design INC.
461 Rue Romeo, Laval, Quebec H7X 1R2, Canada
Copyright © 2020 ve2dx - All Rights Reserved.
(The above picture shows twelve YK1-BT production PCBs; these will be separated into twelve single units after production)
Announcing our YK1-BT RS232 DB9 Bluetooth interface.
This stand-alone female DB-9 device plugs into any Standard RS232c male DB-9 connector and automatically makes it available over Bluetooth.
Great for old and new Kenwood, Yaesu, etc... It could even be used in OEM RS232 DB-9 CAT OEM nonradio devices.
This website uses cookies. By continuing to use this site, you accept our use of cookies.